Wafer Shipping Packing Instructions

Recommended packing method for SPI/Semicon wafer containers

Each wafer jar requires a foam liner, foam cushion discs, and wafer interleaf disc to effectively protect wafers during transport.

Follow these steps

1. Insert the Foam Liner around the inside wall of the wafer jar.
2. Place two Foam Cushion Discs in bottom of wafer jar.
3. Place Wafer Interleaf Disc on top of foam disc.
4. Place one wafer on top of Interleaf and continue putting an Interleaf Disc between each wafer as wafer jar is loaded.
5. Place Wafer Interleaf Disc on top of the last wafer loaded into jar.
6. Fill any empty space in top of jar with Foam Cushion Discs.

IMPORTANT NOTE: To prevent wafer breakage it is critical that the jar is “overfilled” by the thickness of the Foam Cushion Discs. This overfill creates a light compression on wafers when the lid is snapped onto the jar. The compression prevents wafer movement inside the jar which helps to prevent wafer damage. Please note – this “overfilling” procedure is to be used only with the soft foam cushions. When using firm foam in the container overfilling the container can cause breakage of the wafers. Over filling with firm foam can also cause the lid of the container not to seat properly and come off in transport.

The above instructions are intended for packing the 1-1/2″ deep wafer jar with up to 25 wafer. When packing 3″ deep jar with more than 25(up to 50) wafers place Foam Cushion Disc every five wafers.

Wafer Shipping Systems

Wafercon200

The SPI/Semicon Wafer Storage and Shipping Systems includes A Wafer Jar and Lid, Foam Liner, Foam Cushion Discs, and Wafer Interleaf Discs.

Wafer Jars and Lids

Jars and Lids are manufactured from virgin polypropylene resin-no fillers or additives. Material is chemically resistant and has high impact strength.

Foam Liners

Manufactured from 1.25 LB density pink polyurethane antistatic foam. This product is non-corrosive, has excellent cushion properties, and low particle generation. Surface Resistivity (ASTM D256) measures 10 Ohms/Sq. Meets MIL-B-81705 Static Decay Requirement (0% Cutoff) FTMS 101C, 4046 <2 Seconds.

Foam Cushion Discs

Produced from same materials as Foam Liners.

Wafer Interleaf Disc

Paper Disc: 100% Cellulose, Laboratory Grade Low-Lint Filter Paper. Low Sodium (169 PPM) and Sulfur (15-60 PPM) content.

Tyvek Discs: Spunbonded Olefin, tear proof non-particulating. Extremely low Sodium (1 PPM) and Sulfur (1 PPM) content. Special grade resists triboelectric charging.

Note: All of the above products are produced without CFCs or ODCs.

CEN Wafer Containers

8″ Wafer Containers

5 & 6″ Wafer Containers

3 & 4″ Wafer Containers